Log inJoin

Rolls-Royce steering gear: one pump stops the rudder at 10° to one side

Steering GearRolls-Royce

Contents
  1. Symptoms
  2. Checked
  3. Diagnosis
  4. Fix
  5. Comments · 0

Symptoms#

  • With one of the two pumps, the rudder would not go more than 10° to one side.
  • Same in follow-up and non-follow-up.
  • It stopped at exactly 10° every time, from any starting position.
  • Pushing the solenoid valve by hand moved the rudder normally. The other pump worked normally.

Checked#

  • Drawings: each pump has its own rudder limit switches, port and starboard — 4 switches in total.
  • The limit switches get voltage only while the rudder is moving.
  • The maker had recently issued a service letter asking to check these limit switches.

Diagnosis#

The limit switches sit in a closed box. Inside, a disc on a shaft turns together with the rudder (it is linked to the tiller by a chain). Two cams on its back press the limit switches at the end of travel and cut the supply to the solenoid, so the rudder stops.

Limit switch box: the turning disc (left) and the limit switches (right), with dirt inside
Limit switch box: the turning disc (left) and the limit switches (right), with dirt inside

There was a lot of dirt inside the box, although it is sealed. The dirt had slightly bent one limit switch, so it opened at 10° instead of 37°.

Rudder limiter switches (STBD and PORT, normally closed) in the transmitter cut the signal to the pump solenoid
Rudder limiter switches (STBD and PORT, normally closed) in the transmitter cut the signal to the pump solenoid

Fix#

Cleaned the box and corrected the bent limit switch.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in