Why anchors and anchor chains are lost or damaged
EL-0145 · Knowledge · rating 0 · occurred 11 Jul 2022
Source: /cases/el-0145
Notes#
Anchors and chains are lost or damaged through a mix of technical wear, operational mistakes and use beyond the design limits of the equipment. This is a general note, not one fault case.
When anchors or chains are lost or damaged
- The ship drags its anchor in strong current or bad weather.
- The anchor is let go or heaved up in very deep water.
- The anchor runs out with no control from the windlass brake.
- The ship moves too fast through the water while the anchor is let go or heaved up.
- The anchor is caught or damaged on a rocky bottom.
- The windlass clutch comes out of engagement during anchoring.
- The anchor is not secured well for the sea passage.
- The windlass hydraulic motor breaks down.
- The chain stopper fails.
Technical points to check and maintain
| Item | What to look for |
|---|---|
| Shank and flukes | Casting defects; repairs that are poor or not approved |
| Anchor D-shackle and pin | Heavy wear |
| Anchor swivel | Heavy wear |
| Shank, flukes, swivel, D-shackle, chain | Mechanical damage from a rocky seabed |
| Chain links | Wear; reduced diameter |
| Chain studs | Loose (moved) or missing |
| Windlass clutch mating faces | Wear. A worn clutch can jump out of engagement by itself. |
| Windlass brake bands | Heavy wear |
| Chain stopper pins and hinges | Wear or defects |
| Hydraulic motor | Overload from wave loads in deep water or bad weather, which can break the motor |
| Windlass hydraulic oil | Contamination |
| Hydraulic relief valves | Wrong setting |
Operational causes
- Bad choice of anchorage: depth, traffic and seabed type not considered. Deep anchorages, Fujairah for example, need extra care.
- The weather forecast is not followed closely.
- The bridge watch does not monitor the navigation equipment, so dragging or very high chain tension is found too late.
- The wrong way of letting go is chosen: by gravity, or with the windlass motor.
- Bad communication between the bridge and the anchor team on the forecastle.
- The windlass brake is set wrongly.
- The anchor is stowed and secured badly for sea.
Design limits
Anchoring equipment is designed only for the conditions in the IACS rules, wave loads included, and it is important to understand these limits:
- current up to
1.5 m/s(about3 knots) - wind up to
11 m/s(Beaufort 6) - significant wave height up to
2 m - water depth up to
120 m
What this note doesn't cover: chain length, scope, brake holding load, hydraulic pressure settings, wear limits, inspection intervals, or any specific ship, incident or windlass maker.
Further reading
The OCIMF book "Anchoring Systems and Procedures".
Comments · 0
No comments yet.