Log inJoin

Himsen 6H21/32: lowering the main bearing cap far enough to change the bearing

Auxiliary EngineHimsen 6H21/32

Contents
  1. Problem
  2. Lowering the cap with chain blocks
  3. Rolling the upper shell in
  4. Other way: a jack (crankcase oil drained)
  5. Comments · 0

Problem#

When the main bearing cap is lowered with the special tool as the manual says, it goes down only 7–8 cm. That is not enough to change the bearing.

Lowering the cap with chain blocks#

  1. Use two chain blocks on opposite corners of the cap: fore-port and aft-starboard.
  2. The cap has threaded holes (used by the special tool). Fit eye bolts there. A home-made one works: a bolt that fits the hole (about M10–M12) with a nut (about M14) welded on, to hook a thin shackle and wire rope.
  3. Lower the cap evenly with both chain blocks, almost to the bottom. Do not let it come off the studs.
  4. Roll the upper shell out and in with the special tool. Change the lower shell by hand.
  5. Lift the cap back with the chain blocks until the stud threads show below the cap. Then bring it fully up with the nuts.

It takes about 40–50 minutes per bearing, not counting hydraulic tightening.

Rolling the upper shell in#

When you roll the upper shell in with the special plug in the oil hole, keep the plug pulled out a little. If it is pushed in fully, it slips under the shell.

Other way: a jack (crankcase oil drained)#

If the crankcase oil is drained, put a small portable hydraulic jack in the crankcase under the cap (on a wooden beam laid on edge, if it is too low). With the nuts still on, take the load on the jack, remove the nuts, then release the jack pressure. The cap goes down evenly.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in