Shipboard electric motors: routine maintenance checks and tests
EL-0154 · Knowledge · rating 0 · occurred 21 Sept 2022
Source: /cases/el-0154
Notes#
Preventive maintenance of shipboard electric motors comes down to daily attention plus a few periodic checks and tests. The best thing I know is an electro-technical officer (ETO) on board who watches the motors every day: small checks on the daily round prevent large repair costs and equipment downtime. This note is general; it is not about a particular motor, maker, model, rating or fault.
My routine checks. These intervals are my own practice, not maker or class requirements:
- Ball bearings: renew at the interval the maker gives. Check whether the bearing should be the closed or open type. Use bearings from a well-known maker. Keep the motor correctly aligned with the pump.
- Overhaul: complete overhaul every
5 years. Clean the windings then, and varnish them only if needed. - Insulation resistance: megger test
3-4 times a year. - Vibration: take readings
3-4 times a yearand keep them as reference values for later comparison. - Space heater: check that it works.
- Running condition: watch the running current (amps) and listen for noise.
- Temperature and ventilation: check how hot the motor body is and make sure there is enough ventilation.
- Protection: check from time to time that the motor protection trips the motor correctly.
Diagnostic tests that can be used for preventive maintenance:
- Visual and endoscope inspection
- Capacitance and tan delta
- Partial discharge
- Wedge deflection
- ELCID
- Natural frequency test
- Surge test
- Motor circuit analysis
- DC tests
- Residual life assessment
I don't have intervals or acceptance values for these tests.
What this note doesn't cover: insulation test voltage and minimum megohm values, vibration limits or a standard to judge them (for example ISO 10816), greasing intervals and grease type, temperature limits, how to test the motor protection, and maker service letters or class requirements. I take these values from the maker's manual and the vessel's planned maintenance system.
Comments · 0
No comments yet.