Log inJoin

MAN ME-C: "Low stroke" slowdown, exhaust valve position signal drops out

Main EngineMAN B&W ME-CLow stroke

Contents
  1. Symptoms
  2. Checked
  3. Diagnosis
  4. Fix
  5. Result
  6. Comments · 0

Symptoms#

  • Main engine slowdown with "Low stroke" alarm on one cylinder.
  • On the MOP, the exhaust valve position signal from the inductive sensor dropped out about every 3 seconds. Each time, fuel injection to that cylinder was cut off.
  • It started after the exhaust valve was replaced at a shipyard. The old sensor could not be removed, so a new one was fitted.
  • In one week three new sensors were fitted on this cylinder. After the last change the alarm came back after 14 hours, but less often.
  • The new sensor has a fixed cable (the original had a plug). The cable did not reach the CCU and was extended through a WAGO terminal.

Checked#

CheckResult
New sensors on the bench with a tester0 mA — no signal
Third new sensor, straight from the boxNo signal

Two of the new sensors had worked for about one day before failing.

New exhaust valve position sensor, marked 1883819-3
New exhaust valve position sensor, marked 1883819-3

Diagnosis#

The batch of new sensors was defective, possibly not genuine. The boxes and test papers looked normal. An old handover note said the CCU (MPC) of this cylinder had been changed 1.5 years before for the same problem. Changing it again would not have helped.

Fix#

Fitted an old sensor in place of the new one.

Result#

The engine runs normally so far. On another ship the same problem was solved the same way, by going back to the old sensor.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in