Log inJoin

How to check that the AIS transponder is working

Navigation

Contents
  1. Scope
  2. Safety
  3. Tools & parts
  4. Steps
  5. Check after
  6. Comments · 0

Scope#

A simple routine check confirms the shipboard AIS is working: distant targets show the receiver is good, and other ships confirming they see you shows the transmitter and antenna are good. This is the check I use. It is not tied to any maker or model, and it is not a response to a fault, alarm or symptom.

What this check doesn't cover:

  • maker service letters
  • the built-in self-test or the alarm/BITE menu
  • VSWR, antenna cable or connector checks
  • the annual AIS performance test
  • MMSI, static data or GPS input checks
  • how often to do it

Safety#

No special safety points.

Note: while the AIS power supply is off (step 5), the AIS does not work.

Tools & parts#

  • AIS display on board
  • VHF radio to call other ships

No parts are needed.

Steps#

  1. Watch the AIS display for targets more than 25 NM away.
  2. Check whether these far targets appear in a stable and correct way. If they do, this indicates that receiver sensitivity is good enough.
  3. Pick two of these far targets. Call them on VHF.
  4. Ask each ship whether your own ship appears stable and correct on their AIS. If it does, this indicates that transmitter output power and antenna efficiency are good enough.
  5. If the other ships cannot see you, or your ship does not appear correctly, switch the AIS power supply off, then on again.
  6. Do steps 3 and 4 again. Treat the transmitter as faulty only if the check still fails after the power supply is switched off and on.

Check after#

  • Far targets (more than 25 NM) appear stable and correct on your AIS display.
  • Two far ships confirm on VHF that your ship appears stable and correct on their AIS.
  • I have no confirmed fault case or result from this check.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in