Log inJoin

When to replace a radar magnetron

Navigation

Notes#

I replace X-band and S-band radar magnetrons on condition (magnetron current and performance tests), not on running hours alone, and I always keep a spare on board. The maker's hour interval is a prompt to check, not a hard limit.

Two approaches

  • Replace at the interval the maker recommends.
  • Keep the magnetron running until a problem appears.

I prefer the second, on condition that a spare magnetron is always on board.

Maker interval and real life

  • Makers usually recommend replacement at about 4,000 h of running time. At this point the radar shows a replacement reminder on the screen.
  • In my experience, a magnetron can last about 8,000–10,000 h.
  • I keep using the magnetron past the maker's interval as long as performance tests and magnetron current stay inside the maker's limits, and replace it when performance drops.
  • Always keep a spare set of magnetrons on board.

Wear limit by magnetron current

  • Measure the magnetron current at the longest pulse length. If it is down to about half of the as-new value, the magnetron is at the end of its life.
  • This rule needs a reference: the current of the same magnetron when new, at the longest pulse length.

Inspections (third-party or class)

  • For an inspection, the radar is acceptable if it meets IMO Resolution MSC.192(79), especially Table 2 of that resolution.
  • In my view, running hours of the magnetron, or of any other part, do not matter for the inspection; only radar performance counts. A yearly car test does not depend on how long ago the engine oil was changed.

Limits of this information

  • The half-current rule and the 8,000–10,000 h life come from experience, not from a radar maker.
  • I don't have actual magnetron current values in mA, and I have not specified which performance test (for example, a performance monitor or tuning indicator).
  • What this note doesn't cover: magnetron warm-up or ageing after replacement, high-voltage or radiation safety, and maker service letters. Follow the maker's manual for these.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in