EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library
Search
Cases
Search cases
Clear
⌘K
All
3
Solved
3
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
3 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Boll & Kirch filter turns back to the dirty chamber at flushing
Troubleshooting
Other
·
Boll & Kirch 6.72, BK 2200 controller
At backflushing: The solenoid worked and the filter turned to the clean chamber. The solenoid switched off, air was cut, and the filter turned back to the dirty chamber. This happened twice in a row.…
Anonymous · 5 y
▲
0
rating
0
comments
Yanmar generator: low LO pressure shutdown 5 minutes after start
Troubleshooting
Auxiliary Engine
·
Yanmar
After start, LO pressure was normal (4.8 bar), then slowly fell. After 5–6 minutes at most, the engine shut down on low LO pressure. The differential pressure indicator on the automatic LO filter…
Anonymous · 4 y
▲
0
rating
0
comments
Terasaki PMS: generator will not parallel in auto, "ACB non close"
Troubleshooting
Electrical
·
Terasaki PMS
·
ACB non close
When a generator was put in parallel in automatic mode, the alarm "ACB non close" came up. The breaker did not close and the engine stayed running with no load. Frequency and voltage were the same as…
Anonymous · 4 y