Search
Cases
Search cases
Clear
⌘K
All
8
Solved
5
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
5 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Alfa Laval plate FWG: high brine temperature (60 °C) and low output
Troubleshooting
Fresh Water Generator
·
Alfa Laval (plate type)
Low fresh water output and brine temperature up to 60 °C. Cleaning the plates did not help. Vacuum and heating water were normal. Readings, the same before and after cleaning: Reading Value Heating…
Anonymous · 10 mo
▲
0
rating
0
comments
Aalborg boiler will not light after changeover from HFO to MDO
Troubleshooting
Boiler
·
Aalborg composite boiler
·
Flame out
After changeover from heavy fuel to MDO, the burner did not light. At each start it tripped on flame out.
Anonymous · 6 y
▲
0
rating
0
comments
220 V insulation alarm every morning, gone before you reach the switchboard
Troubleshooting
Electrical
·
Low insulation 220 V
Low insulation alarm on the 220 V system early every morning, at breakfast time. By the time the engineer reached the switchboard, the reading was normal again. It started when a new cook joined the…
Anonymous · 2 y
▲
0
rating
0
comments
Siemens LOGO! fuel changeover: program loaded but does not run
Troubleshooting
Automation / PLC
·
Siemens LOGO! 230RC with DM8 230R and AM2 expansion modules
·
Control fail
The automatic HFO/MDO changeover (valves and fuel heating) is controlled by a Siemens LOGO! 230RC with expansion modules. A "Control fail" alarm came up on the fuel page of the control PC. Expansion…
Anonymous · 3 y
▲
0
rating
0
comments
Ballast pump coupling stuck: removed without heat using an extractor and jack
Troubleshooting
Pumps
A stuck coupling flange on a tanker ballast pump can be pulled off without heat using a home-made extractor and a hydraulic jack. That is how we freed ours. The ballast pump sits in the pump room of…
Anonymous · 2 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library