SOx scrubber failure: what to do to stay compliant (MEPC.1/Circ.883)
EL-0153 · Procedure · rating 0 · occurred 26 Jul 2022
Source: /cases/el-0153
Scope#
When the exhaust gas cleaning system (EGCS, SOx scrubber) fails and no longer meets the scrubber guidelines, I follow IMO MEPC.1/Circ.883, which covers EGCS malfunctions. This procedure sets out the on-board compliance actions from that circular. DNV also has a flow diagram of these steps; I have not reproduced it here.
This is general compliance guidance, not repair experience, and it is not tied to a ship, scrubber maker or model. It does not cover troubleshooting of specific faults (pumps, nozzles, CEMS calibration and so on), or Port State and ECA local rules.
Safety#
This procedure has no specific safety content. For any repair work, I follow the ship's safety procedures and the class-approved EGCS Technical Manual. Do not bypass any safety device or interlock.
Tools & parts#
No specific tools or spare parts. The documents involved are:
- Class-approved EGCS record book
- Class-approved EGCS Technical Manual
- Action plan for Class and Flag (when needed)
Steps#
- Record every malfunction. Enter each EGCS malfunction in the class-approved EGCS record book. Try to find the root cause. Use the class-approved EGCS Technical Manual for the repair.
- Malfunction longer than
1 h, or repeated malfunctions:- Report to Class and Flag, with a plan to fix the problem.
- Change over to compliant (low-sulphur) fuel.
- If there is not enough compliant fuel on board, inform Class and Flag. The ship may then continue on high-sulphur fuel until the first convenient bunkering port.
- Submit an action plan for approval.
- Short SO2/CO2 ratio spikes in transient conditions. Short peaks are acceptable, for example during sudden main engine load changes. No further action is needed. The EGCS Technical Manual should list these transient conditions.
- Failure of one monitoring sensor (SO2/CO2 ratio, washwater pH, PAH or turbidity). The EGCS may stay in use without a fuel changeover if all of these are done:
- Record the readings of the sensors that still work at the time of the failure. If they match the values from before the failure, the fault is likely in the instrument only, and the exhaust and washwater limits are still met.
- Record the sulphur content of the fuel burned since the sensor failed.
- Fit a new sensor in place of the faulty one at the first practical chance.
Check after#
- Every malfunction is entered in the EGCS record book, with root cause and repair.
- For a failure over
1 hor repeated failures: Class and Flag were informed, the fuel changeover was done (or the lack of compliant fuel was reported), and the action plan was submitted. - For a single sensor failure: readings of the working sensors and the fuel sulphur content are recorded, and the faulty sensor is replaced.
I have no outcome from a real case to report.
Comments · 0
No comments yet.