Fuel oil purifiers: how to remove more cat fines
EL-0156 · Knowledge · rating 0 · occurred 16 Jul 2022
Source: /cases/el-0156
Notes#
To remove more catalytic fines (cat fines), fuel oil purifiers (centrifugal separators) need low throughput, the right temperature and good maintenance. These are my general notes; there is no specific fault case and no separator maker or model.
Why efficiency matters
- Fuel with more cat fines needs a very efficient purifier. In some cases removal efficiency must be over
80%. - Engine makers set a cat fines limit of
15 mg/kg, while ISO 8217 can accept bunker fuel with up to60 mg/kg. In my view, the purifiers must close this gap.
What I do to improve separation
- Follow the maker's maintenance routines, with special care for cleaning the disc stack and the bowl.
- Use genuine spare parts and keep up regular maintenance.
- Lower the flow rate through the purifier. Keep it as low as operation allows.
- Raise the separation temperature a little, to an inlet temperature of about
98-99 °C. - Set the flushing / desludge interval to match how much sludge each fuel gives.
- Test the separator efficiency at least once a year.
Throughput and efficiency
- I have seen a graph showing that at
10%of rated capacity efficiency rises by about300%. I don't have the axes or the rest of the curve, so treat this number as a rough indication only.
Draining settling and service tanks
- Drain water and sludge often from the settling and service tanks, perhaps every
2-4 h. - This does not make the purifier itself separate better. The gain is that the engines receive better fuel.
- Every crew drains tanks in its own way, for example twice a day. I don't know whether draining every
2 hlowers cat fines at the injectors by a measurable amount. This point is still open.
What this note doesn't cover
- Actual flow rates in
l/h, or gravity disc and density settings. - Measured cat fines results before and after changes.
- The method used to test separator efficiency.
- Any maker service letter or class notice.
Comments · 0
No comments yet.