Log inJoin

Main engine liners: how often to do external wear scanning

Main Engine

Notes#

External electronic scanning of main engine cylinder liners by an outside company is worth doing; what is not settled is how often, at least yearly or about every 5 years backed by onboard monitoring. This note sets out both approaches. It is general, with no engine maker, model, ship or wear readings.

Case for external measurement at least once a year

  • Bad fuel can cause severe liner damage, which makes the measurements more useful.
  • Inspecting the liners before dry dock tells the office the liner condition, so new liners can be ordered early.
  • Liner readings from the crew are not always reliable. That argues for external measurements at least once a year.

Case for onboard monitoring, with a third party about every 5 years

  • External scanning without pulling the piston gives useful data and helps to find abnormal liner wear.
  • Depending too much on outside firms can cost the crew and the superintendents their skills.
  • The ship can watch liner condition with its own methods:
    • scavenge port inspections
    • scrape-down oil analysis
    • liner calibration when the piston is overhauled
    • engine performance measurements
  • On this approach, a third-party liner inspection about every 5 years is enough, sooner if the onboard reports are in doubt.

Not settled

The two approaches differ on frequency: external measurement at least yearly, or a third party about every 5 years plus regular onboard monitoring. I have not settled this.

What this note doesn't cover

  • Engine maker or model, liner wear limits (in mm or % of bore), maker service letter references.
  • Names of measuring equipment or service companies.
  • Any real fault case or measured values.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in