How to take one cylinder out of service on MAN ME-C

Main EngineAutomation / PLCMAN ES ME-C

Contents
  1. Scope
  2. Safety
  3. Tools & parts
  4. Steps
  5. Check after
  6. Comments · 0

Scope#

To take one cylinder unit out of operation on an ME-C (electronically controlled 2-stroke) main engine, I set the Chief Index limit for that cylinder to 0 on the MOP. This is an outline only. The full procedure is in the M/E instruction manual, in the chapter "How to take a cylinder unit out of operation". Read that chapter before you start.

What this note doesn't cover

  • HCU (hydraulic cylinder unit) isolation, locking the exhaust valve open or closed, and the starting air valve.
  • Cylinder lube oil (Alpha lubricator) settings for the isolated unit, and whether to lift the fuel pump or plunger.
  • Allowed load or rpm with one cylinder cut out, actual barred speed values, and the alarms and MOP values that appear when a cylinder is cut out.
  • Any maker service letter.

Safety#

  • With one cylinder out of operation, the engine has an extra barred speed range. This range is not given in the M/E manual. Look for it in the torsional vibration calculation for the engine.
  • Tell the Master and the Chief Engineer about this extra range, so that the engine is not run in it.
  • Follow the maker's manual for all steps that this note does not cover.

Tools & parts#

  • MOP (Main Operating Panel)
  • M/E instruction manual
  • Torsional vibration calculation for the engine

Steps#

  1. Read the M/E manual chapter "How to take a cylinder unit out of operation".
  2. On the MOP, open the Chief Limiters screen. On these engines, in an emergency, this is the only place where the fuel booster of one cylinder can be isolated.
  3. Set the Chief Index limit for that cylinder to 0. With this setting, the cylinder has no combustion.
  4. Decide what to do with the exhaust valve of that unit. It is usually left working, so that the engine stays partly balanced. This is not always the right choice: sometimes the exhaust valve has to be switched to "Disabled" and held in a locked position, either open or closed. I can't say which cases need this; follow the manual.
  5. Find the extra barred speed range for running with one cylinder out, in the torsional vibration calculation.
  6. Inform the Master and the Chief Engineer of this range.

Check after#

  • Check on the MOP that the Chief Index limit for the isolated cylinder shows 0.
  • Check that the exhaust valve of the unit is in the state you chose (working, or locked open or closed).
  • Make sure the engine does not run in the extra barred speed range.

Still open: the alarms and MOP values to expect with a cylinder cut out, and the maximum engine load with one cylinder off for each engine type and cylinder number.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in