Two-stroke piston rings: what cermet and alu-bronze coatings do
EL-0179 · Knowledge · rating 0 · occurred 06 Jul 2022
Source: /cases/el-0179
Notes#
Context
- The engine type is a large two-stroke, slow-speed diesel main engine.
- A colleague asked me about the purpose of the two coatings on M/E piston rings: aluminium and cermet.
- I answered on the same day. Mine was the only answer, and nobody disagreed with it. I added one image, but what it showed is not recorded here.
Cermet coating (bottom layer)
- Cermet is made of ceramic and metal together. It goes directly on the base metal of the ring.
- Its purpose is to stop scuffing and to keep ring wear low.
- In my experience, this coating is now standard on long-stroke, large-bore, slow-speed diesel engines. Gas-fuelled engines use it too.
- This is the layer that protects the ring against scuffing and wear.
Aluminium-bronze ("alu") coating (top layer)
- The cermet is covered by this second layer.
- It is there for running-in. It gives a smooth surface on both the rings and the liners.
- Usually it is gone after the first
1,000to3,000running hours.
Practical point
- The alu-bronze layer is meant to wear away during running-in. So if a ring has passed about
1,000–3,000 hand this layer is missing, this alone may be expected wear. I did not cover how to judge ring condition. Check the rings and the cermet layer against the engine maker's limits.
Not covered here
- Engine maker or model, ring maker.
- Coating thicknesses and wear limits.
- How to inspect the rings.
- Running-in procedure, such as load steps or cylinder oil feed rate.
- Any maker service letter.
Comments · 0
No comments yet.