Log inJoin

Bent propeller blade tip: straightening in place, then PT check

Propulsion & Thrusters

Contents
  1. Scope
  2. Safety
  3. Tools & parts
  4. Steps
  5. Check after
  6. Comments · 0

Scope#

A bent propeller blade tip can be straightened in place by heating, by pressing, or both, followed by a dye penetrant (PT) check. This is the outline of how I did this repair; it is not a common job.

There are two ways to straighten the tip:

  • Heat method: heat the bent area with a torch first.
  • Mechanical method: push the tip back with a press or a fork-type tool.

The amount of bend and the shape of the deformation decide which method to use, or whether to use both together.

This is only an outline. It does not record the propeller maker or model, the blade material, or whether the ship was in drydock or afloat.

Safety#

  • Heating is done with a torch. Treat it as hot work.
  • I give no heating temperature, temperature limit or limit for cold straightening here. Get these values from the propeller maker or the applicable repair standard before you start.
  • Check whether class or a maker's repair standard applies before you start.

Tools & parts#

  • Torch for heating the blade
  • Press or fork-type straightening tool
  • Material to wrap the heated area so it cools slowly
  • Sanding tools
  • Dye penetrant (PT) kit

Steps#

  1. Look at how far the tip is bent and at the shape of the deformation. Choose heat, mechanical straightening, or both.
  2. If you use heat, warm the bent area with the torch. Heat makes the material softer, so it is less likely to crack when you straighten it.
  3. Straighten the tip with the press or fork tool. Bring it back as close to its correct shape as you can. I don't give a target value.
  4. After heating, wrap the heated area so it cools slowly and in a controlled way, which keeps residual stress low.
  5. Let the area cool to ambient temperature. Then sand it to remove the marks left by the fork or tool.

Check after#

  • Do a dye penetrant (PT) test on the repaired area to look for cracks.
  • What this note doesn't cover: acceptance tolerance, how blade pitch or profile is measured after the repair, whether the propeller was balanced afterwards, or the final result of the repair.

Comments · 0

No comments yet.

Sign in to comment, vote and confirm fixes.Sign in