EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library
Search
Cases
Search cases
Clear
⌘K
All
4
Solved
3
Open
1
Troubleshooting
Incident analysis
Procedure
Knowledge
4 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
answers
Main engine scavenge drain tank level rising: piston crown O-ring leak suspected
Troubleshooting
Open
Main Engine
The level in our main engine scavenge drain tank keeps going up, and I suspect system oil leaking into the scavenge space from the piston crown O-rings. The engine has a scavenge space, so it is most…
Anonymous · 3 y
▲
0
rating
0
comments
Switchboard earth lamps do not light, only one of three on lamp test
Troubleshooting
Electrical
The insulation resistance monitor (IRM) worked normally. The earth lamps did not light. With the test button pressed, only one of the three lamps lit.
Anonymous · 3 mo
▲
0
rating
0
comments
NMF deck crane: no POWER REQUEST after flooding, CPU blinks RUN/STOP
Troubleshooting
Deck Machinery
·
NMF crane, Moeller XC-CPU201
The cranes were badly flooded: slip rings and control panels. Slip rings and panels were cleaned and dried. The cranes had been without power for 2 days. Cranes 1 and 3 started. On crane 2 the POWER…
Anonymous · 3 y
▲
0
rating
0
comments
Main engine piston crowns burnt: long low-load running and bad injectors
Troubleshooting
Main Engine
Burn marks on our main engine piston crowns came, as far as we can tell, from long running at low load together with faulty fuel injectors. I found burn marks on the combustion side of the piston…
Anonymous · 4 y