EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library
Search
Cases
Search cases
Clear
⌘K
All
4
Solved
4
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
4 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Carel ir33 refrigeration controller: alarm E05 when setpoint is below -18 °C
Troubleshooting
Refrigeration & HVAC
·
Carel ir33
·
E05
With the setpoint at -18 °C everything works. With the setpoint at -18.5 °C or lower, alarm E05 comes. The plant still works and reaches -18.5, -19, -20 °C as set, but the alarm stays.
Anonymous · 6 y
▲
0
rating
0
comments
SAM Electronics ME HT cooling: temperature swings 8 °C in auto
Troubleshooting
Main Engine
·
SAM Electronics
The ME HT cooling water temperature controller (HT cooler valve) could not hold the set point in auto. The temperature went up and down by about 8 °C. Because of this, the system was run in manual…
Anonymous · 1 y
▲
0
rating
0
comments
Hi Air Korea AC: compressor will not start, "FRESH ARM 1CRUN"
Troubleshooting
Refrigeration & HVAC
·
Hi Air Korea
·
FRESH ARM 1CRUN
The AC compressor did not start. No alarms were showing. When starting the compressor, only the controller on the AC control panel showed a new alarm: FRESH ARM 1CRUN. The manuals do not explain this…
Anonymous · 4 mo
▲
0
rating
0
comments
Sauer air-cooled service air compressor overheats (105 °C)
Troubleshooting
Compressed Air
·
Sauer Compressors, Air Control 1 controller
The air-cooled service air compressor overheated. The controller showed 105 °C at 5.6 bar.
Anonymous · 2 y