Search
Cases
Search cases
Clear
⌘K
All
5
Solved
4
Open
1
Troubleshooting
Incident analysis
Procedure
Knowledge
5 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Consilium CS4000: new manual call point gives "No answer"
Troubleshooting
Fire & Safety
·
Consilium CS4000
·
No answer
An old manual call point (P/N 11305) was replaced with the new type MCP-A, P/N 5200030-01A. The system did not find the new unit: alarm "No answer" for its address, although the address was set…
Anonymous · 1 y
▲
0
rating
0
comments
Scrubber: "CEMS failure" alarm every 4 minutes, no alarm on the SICK analyser
Troubleshooting
Other
·
SICK CEMS
·
CEMS failure
The scrubber panel shows "CEMS failure" about every 4 minutes. Sometimes there is no alarm for about 20 minutes, then it comes back. The CEMS itself shows no new alarm. Its status goes to Stop and…
Anonymous · 3 y
▲
0
rating
0
answers
Stern tube oil: high copper, cooler or pump wear suspected
Troubleshooting
Open
Propulsion & Thrusters
Our stern tube lube oil showed high copper (60-80 ppm); the cause is not confirmed, and I suspect wear in the oil cooler or circulating pumps rather than the bearing. Lab analysis of the stern tube…
Anonymous · 4 y
▲
0
rating
0
comments
Eltek fire panel: "Fault in addressable loop", but all detectors test OK
Troubleshooting
Fire & Safety
·
Eltek
·
FAULT IN ADDRESSABLE LOOP: 01
The panel showed FAULT CONDITION: "FAULT IN ADDRESSABLE LOOP: 01". The FAULT lamp was on. The loop worked: the detector test on this loop passed. The manual has no description of this fault. The…
Anonymous · 3 y
▲
0
rating
0
comments
Ballast pump coupling stuck: removed without heat using an extractor and jack
Troubleshooting
Pumps
A stuck coupling flange on a tanker ballast pump can be pulled off without heat using a home-made extractor and a hydraulic jack. That is how we freed ours. The ballast pump sits in the pump room of…
Anonymous · 2 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library