EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library
Search
Cases
Search cases
Clear
⌘K
All
4
Solved
3
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
4 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Panasia PAS-200 isolator: input drops to 6.5 V under load
Troubleshooting
Automation / PLC
·
Panasia PAS-200
New PAS-200 signal isolators (1 input, 2 outputs) were fitted in the cargo control room in place of old ones. With nothing connected, the input voltage was 24 V. With a P/I converter connected, the…
Anonymous · 2 y
▲
0
rating
0
comments
Daihatsu 6DK generator: testing overspeed without a test button
Knowledge
Auxiliary Engine
·
Anqing Daihatsu 6DK, Nanjing Chuzheng speed switch
The generator engine has a separate speed switch unit (Nanjing Chuzheng). It has no test button. The settings on its label: Setting Value Low speed 300 rpm Rated speed 720 rpm Overspeed 815 rpm…
Anonymous · 6 y
▲
0
rating
0
comments
Kangrim boiler: "Flame failure" alarm while stopped, will not reset
Troubleshooting
Boiler
·
Kangrim
·
Flame failure
FLAME FAILURE alarm came up while the boiler was stopped (not firing). The alarm could not be reset. A restart did not help.
Anonymous · 2 y
▲
0
rating
0
comments
Boll & Kirch filter turns back to the dirty chamber at flushing
Troubleshooting
Other
·
Boll & Kirch 6.72, BK 2200 controller
At backflushing: The solenoid worked and the filter turned to the clean chamber. The solenoid switched off, air was cut, and the filter turned back to the dirty chamber. This happened twice in a row.…
Anonymous · 5 y