Search
Cases
Search cases
Clear
⌘K
All
20
Solved
6
Open
1
Troubleshooting
Incident analysis
Procedure
Knowledge
6 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Atlas incinerator will not burn sludge: no start signal to dosing pump
Troubleshooting
Incinerator & Sewage
·
Atlas
The incinerator would not burn sludge. Chamber temperature rose normally and reached the set point for starting the sludge burner. But the PLC gave no output signals: no "dosing pump ready to start",…
Anonymous · 6 y
▲
0
rating
0
comments
Emergency generator trips on blackout test, then will not close on the bus
Troubleshooting
Electrical
·
Schneider Electric ComPacT NSX630
Blackout test from the main switchboard: the supply to the emergency switchboard was switched off. The emergency generator started, closed onto the bus and took the load. After 5–10 minutes it…
Anonymous · 6 mo
▲
0
rating
0
comments
SEA-Mate B500 blender stops after blending, blend not discharged
Troubleshooting
Main Engine
·
Marine Fluid Technology SEA-Mate Blender B500
In auto mode the unit mixes the oils, then stops and stays stopped. It should open the valve and pump the blend on, but it does not. No alarm.
Anonymous · 3 y
▲
0
rating
0
comments
Dual-fuel main engine: loud bangs and many alarms when changing over to gas
Troubleshooting
Main Engine
The main engine was started and changed over to gas. Loud bangs from the engine and many alarms.
Anonymous · 7 mo
▲
0
rating
0
comments
Hyundai steering gear: pump stops 4 seconds after start from the bridge
Troubleshooting
Steering Gear
·
Hyundai
In the evening the running steering gear pump stopped, and the standby pump started. Started from the bridge (autopilot), the pump motor ran for about 4 seconds and then stopped. No alarms on the…
Anonymous · 3 y
▲
0
rating
0
comments
Mitsubishi deck crane will not start after a limit switch stop
Troubleshooting
Deck Machinery
·
Mitsubishi
The crane limit switches were being tested during a class survey. A limit switch tripped and the crane stopped. After that the crane would not start at all. There were no alarms.
Anonymous · 1 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library