EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library
Search
Cases
Search cases
Clear
⌘K
All
5
Solved
0
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
5 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Generator overhaul: checklist to prevent con-rod failures afterwards
Procedure
Auxiliary Engine
Most serious damage to an auxiliary diesel generator (D/G) comes a few hours after a general overhaul, usually from connecting rod or rod bolt failure; this is the checklist I use to prevent it. It…
Anonymous · 4 y
▲
0
rating
0
comments
Using a new bunker before the lab report arrives: precautions
Procedure
Main Engine
When a ship has to change over to a new bunker before the lab report arrives, I treat the fuel as suspect and run with extra precautions on fuel treatment and engines until the result is known. The…
Anonymous · 4 y
▲
0
rating
0
comments
Fresh water generator: checklist for low output or high salinity
Procedure
Fresh Water Generator
This is my checklist for a fresh water generator (FWG) that makes too little water or gives high salinity in the distillate. It applies to a vacuum evaporator heated by engine jacket water, where an…
Anonymous · 4 y
▲
0
rating
0
comments
Main switchboard low insulation: find the fault by isolating loads
Procedure
Electrical
·
Low insulation
This is how I find the cause of a low insulation alarm or low reading on the main switchboard (MSB): isolate all loads, then reconnect them one at a time while watching the insulation monitor. It…
Anonymous · 4 y
▲
0
rating
0
comments
HFO to MGO changeover: cool slowly and watch viscosity
Procedure
Main Engine
Changing the main engine and diesel generators from HFO to MGO is safe if fuel temperature falls slowly and viscosity stays between 2 cSt and 20 cSt. This is the general procedure I use; it follows…
Anonymous · 3 y