Skip to content
EngineLog
Home
Cases
Assistant
Library
Home
Cases
Assistant
Library
Search
Cases
Search cases
Clear
Ctrl+K
All
5
Solved
0
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
5 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
MAN ME: internal leak test on the hydraulic system
Procedure
Main Engine
·
MAN ES ME-type main engine
This procedure is for MAN ES main engines with electronic control (ME type). It covers the hydraulic power supply (HPS) pumps, the hydraulic cylinder units (HCU) and the safety and accumulator block.…
Anonymous · 4 y
▲
0
rating
0
comments
Bent propeller blade tip: straightening in place, then PT check
Procedure
Propulsion & Thrusters
A bent propeller blade tip can be straightened in place by heating, by pressing, or both, followed by a dye penetrant (PT) check. This is the outline of how I did this repair; it is not a common job.…
Anonymous · 3 y
▲
0
rating
0
comments
Main switchboard low insulation: find the fault by isolating loads
Procedure
Electrical
·
Low insulation
This is how I find the cause of a low insulation alarm or low reading on the main switchboard (MSB): isolate all loads, then reconnect them one at a time while watching the insulation monitor. It…
Anonymous · 4 y
▲
0
rating
0
comments
BWTS in muddy ports: filters clog, how to ballast and when to bypass
Procedure
Ballast System
Ballasting in very muddy water clogs and can damage the BWTS filter; this note covers how I ballast in those ports and when a bypass is allowed. In my experience this happens mostly in Chinese ports.…
Anonymous · 4 y
▲
0
rating
0
comments
How to take one cylinder out of service on MAN ME-C
Procedure
Main Engine
·
MAN ES ME-C
To take one cylinder unit out of operation on an ME-C (electronically controlled 2-stroke) main engine, I set the Chief Index limit for that cylinder to 0 on the MOP. This is an outline only. The…
Anonymous · 4 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library