Search
Cases
Search cases
Clear
⌘K
All
5
Solved
5
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
5 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Teamtec OG400 incinerator: "Communication failure PLC - display" after battery change
Troubleshooting
Incinerator & Sewage
·
Teamtec OG400
·
Communication failure PLC - display
The PLC battery was replaced with the incinerator switched off from the mains. After switching on: "Communication failure PLC - display". All PLC data and settings were lost.
Anonymous · 5 y
▲
0
rating
0
comments
NMF deck crane: no POWER REQUEST after flooding, CPU blinks RUN/STOP
Troubleshooting
Deck Machinery
·
NMF crane, Moeller XC-CPU201
The cranes were badly flooded: slip rings and control panels. Slip rings and panels were cleaned and dried. The cranes had been without power for 2 days. Cranes 1 and 3 started. On crane 2 the POWER…
Anonymous · 3 y
▲
0
rating
0
comments
Emergency generator will not crank on batteries that test OK
Troubleshooting
Auxiliary Engine
The emergency generator did not start on the electric starter, from the remote panel or from the local panel on the engine. The engine turned over once or twice, then stopped cranking. The start…
Anonymous · 4 y
▲
0
rating
0
comments
Autronica: loop fault on Ex detector stays after barrier replacement
Troubleshooting
Fire & Safety
·
Autronica, BZB 500 interface unit
·
LOOP FAULTS: LOOP 01 / POINT FAULTS: 10106 SD(EXI)
Open-circuit fault on the paint store detector line. The panel showed "LOOP FAULTS 1 LOOP 01" and "POINT FAULTS 1 10106 SD(EXI)". The system did not see the detector.
Anonymous · 1 y
▲
0
rating
0
comments
Consilium CS4000: new manual call point gives "No answer"
Troubleshooting
Fire & Safety
·
Consilium CS4000
·
No answer
An old manual call point (P/N 11305) was replaced with the new type MCP-A, P/N 5200030-01A. The system did not find the new unit: alarm "No answer" for its address, although the address was set…
Anonymous · 1 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library