Search
Cases
Search cases
Clear
⌘K
All
5
Solved
3
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
5 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Westfalia OSD 60-91: bowl does not close, ejection monitoring alarm
Troubleshooting
Purifier
·
Westfalia OSD 60-91
·
Ejection monitoring
Two main engine LO separators stopped one after the other on the ejection monitoring alarm. On both, the bowl did not close at all. No discharge either, not even a small one. No. 1 stopped 1,000…
Anonymous · 2 y
▲
0
rating
0
comments
Westfalia OSD 18: weak sludge discharge when hydrophore pressure is low
Troubleshooting
Purifier
·
Westfalia OSD 18
Poor sludge discharge: no normal "bang", the bowl only "sneezes" and little comes out. Everything else worked correctly. With the hydrophore at 5.1–5.6 bar the discharge was normal. At 4.3 bar the…
Anonymous · 4 y
▲
0
rating
0
comments
Alfa Laval SA805 lube oil separator: bowl opens by itself after about 10 hours
Troubleshooting
Purifier
·
Alfa Laval SA805
·
Low back pressure
The separator ran for about 10 hours, then the bowl opened by itself. The closing water went to the drain, and nothing held the bowl closed. Alarm: "Low back pressure". The other two separators…
Anonymous · 4 y
▲
0
rating
0
comments
LNG dual-fuel ship: how the fuel gas supply system works
Knowledge
Main Engine
The fuel gas supply system (FGSS) on an LNG dual-fuel ship controls boil-off gas pressure in the LNG fuel tanks and turns LNG into gas for the engines and boilers; its design is set mainly by the…
Anonymous · 3 y
▲
0
rating
0
comments
Aft stern tube bearing wiped by partial propeller immersion
Knowledge
Propulsion & Thrusters
Running with the propeller not fully immersed puts off-centre thrust on the shaft, which edge-loads the aft stern tube bearing and can wipe its white metal within minutes. My main reference is DNV GL…
Anonymous · 4 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library