Search
Cases
Search cases
Clear
⌘K
All
9
Solved
3
Open
0
Troubleshooting
Incident analysis
Procedure
Knowledge
9 cases match
Equipment
All
Main Engine
Auxiliary Engine
Turbocharger
Boiler
Purifier
Compressed Air
Pumps
Fresh Water Generator
OWS & Bilge
Incinerator & Sewage
Refrigeration & HVAC
Steering Gear
Propulsion & Thrusters
Deck Machinery
Ballast System
Electrical
Automation / PLC
Navigation
Fire & Safety
Other
Sort
Best match
Newest first
Highest rated
Most confirmed
Recently updated
Apply
▲
0
rating
0
comments
Sauer air-cooled service air compressor overheats (105 °C)
Troubleshooting
Compressed Air
·
Sauer Compressors, Air Control 1 controller
The air-cooled service air compressor overheated. The controller showed 105 °C at 5.6 bar.
Anonymous · 2 y
▲
0
rating
0
comments
Two-stroke main engine: jobs to do while stopped in port or at anchor
Knowledge
Main Engine
·
MAN ES ME / MC
This is my checklist of jobs to plan when the two-stroke main engine is stopped in port or at anchor and there is a good chance to do the work. It leaves out inspections that are due by running…
Anonymous · 4 y
▲
0
rating
0
comments
Main engine turbocharger surging: causes and prevention
Knowledge
Turbocharger
I wanted to know what turbocharger surging is and how to prevent it. One other engineer answered, and I accepted that answer. This is general guidance. It is not a real fault case. No engine or…
Anonymous · 4 y
▲
0
rating
0
comments
MAN B&W two-stroke: limits for judging engine performance
Knowledge
Main Engine
·
MAN B&W MC/MC-C, ME/ME-C/ME-B
This is my checklist of practical limits for judging the performance of MAN B&W two-stroke main engines, both mechanical (MC/MC-C) and electronic (ME/ME-C/ME-B). I don't have the source of the limits…
Anonymous · 3 y
▲
0
rating
0
comments
How to inspect the scavenge space on a two-stroke main engine
Procedure
Main Engine
·
MAN ES
This is how I do a scavenge space inspection on a 2-stroke main engine through the scavenge ports in the liner, plus the checks I make for water carry-over. Inspect often. Regular checks let you see…
Anonymous · 4 y
▲
0
rating
0
comments
Main engine EGR: deposits and wear depend mainly on fuel sulphur
Knowledge
Main Engine
On a two-stroke main engine EGR (exhaust gas recirculation) system, fuel sulphur content is the main factor behind deposits in the air cooler and scavenge receiver and the amount of drain water and…
Anonymous · 4 y
▲
0
rating
0
comments
Main engine piston crowns burnt: long low-load running and bad injectors
Troubleshooting
Main Engine
Burn marks on our main engine piston crowns came, as far as we can tell, from long running at low load together with faulty fuel injectors. I found burn marks on the combustion side of the piston…
Anonymous · 4 y
▲
0
rating
0
comments
Fresh water generator: checklist for low output or high salinity
Procedure
Fresh Water Generator
This is my checklist for a fresh water generator (FWG) that makes too little water or gives high salinity in the distillate. It applies to a vacuum evaporator heated by engine jacket water, where an…
Anonymous · 4 y
▲
0
rating
0
comments
Volvo Penta D16: con-rods through crankcase from swapped big-end caps (Wight Sky)
Incident
Main Engine
·
Volvo Penta D16 MH
·
ME2 low LO pressure shutdown; ME4 common alarm
Ro-ro ferry with four Volvo Penta D16 MH high-speed MEs; one or two drive each Voith Schneider unit through fluid couplings. Wight Sky had three catastrophic ME failures in 15 months. The 2017 one…
Anonymous · 4 y
EngineLog
Home
Cases
Assistant
Library
Log in
Join
Home
Cases
Assistant
Library